Milnor 30015T5E Bedienungsanleitung PDF herunterladen (Seite 8)

Chapter 3. Troubleshooting

PELLERIN MILNOR CORPORATION

Chapter 3

Troubleshooting

BICEUT04 (Published) Book specs- Dates: 20080219 / 20080219 / 20080219 Lang: ENG01 Applic: CEU

3.1. Troubleshooting Errors

3.1.1. Vibration Switch Tripped

If the machine vibrates excessively during extract, a vibration switch ends the extract step and starts

the subsequent coast step. The formula then continues normally.

3.1.2. Door Open

WARNING 1 : Entangle and Sever Hazards—Cylinder door interlock—Operating the

machine with a malfunctioning door interlock can permit opening the door when the cylinder is

turning and/or starting the cycle with the door open, exposing the turning cylinder.

• If the basket continues to turn when the door is open, stop using the machine immediately

and contact an authorized maintenance person.

The machine will operate normally as long as the door is closed. If the door opens, the machine

stops. For safety, all machine controls are disabled for 75 seconds after the door opens.

If the door opens while the machine is operating, the In Progress light and the Last Rinse light flash.

Both lights flash on for two seconds, then turn off for two seconds, repeating for 10 minutes. After

10 minutes, the lights remain off.

To start the machine again:

1. press the Terminate button (

) to recover from this error,

2. ensure that the door is securely closed,

3. then start the formula again.

3.1.3. Door/Inverter Fault

This error indicates one of three conditions:

• the operator selected a formula before closing the door,

• the door opened while the machine was operating, or

• the inverter sensed a fault during operation.

3.1.3.1. Door/Inverter Fault Before a Formula Starts—You must close the door before

selecting a formula. If the door is open when you press one of the Formula Selection buttons, the

controller recognizes an error condition.

1 2 3 4 5 6 7 8 9

Keine Kommentare

Milnor 30015T5E Bedienungsanleitung Seite 8