Milnor 30015T5E Installationshandbuch Seite 32

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 50
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 31
Chapter 4. Testing and Troubleshooting
PELLERIN MILNOR CORPORATION
Then press the
Terminate
button (
z
) to clear the error condition. Finally, hold the
Door Unlock
button (
'
) and press firmly on the door latch handle.
After correcting any error with the inverter itself, start the formula again.
— End of BICEUT03
Document ..............BICEUT0
2
S
p
ec Date ................ 2001012
2
4.2. Testing TxE Washer-extractors
As-of Date ............... 2001012
2
4.2.1.
Testing without the Display Kit
Most functions of this machine can be tested with an accurate digital voltmeter if the
schematic diagrams are available and you have a thorough understanding of how the machine
normally operates.
The following rules will help you determine the current machine event. The events in each
formula are listed in “TxE Event Timing” (see table of contents).
1. The
In Progress
light turns
on
, the drain
closes
, the commanded water valves
open
, and the
door locks as soon as a formula is selected.
2. The basket begins rotating clockwise four seconds after the
In Progress
light turns
on
. After
20 seconds of clockwise rotation, the basket dwells for four seconds, then rotates counter-
clockwise for 20 seconds.
3. When the desired level is achieved, the water valves
close
and the formula timer runs.
4. Signals for the injection of any desired chemicals occur 15 seconds after the timer starts
counting for the bath. Chemical injection signals last 30 seconds.
5. The chemical manifold flush signal activates 15 seconds after the chemical injection signal
ends, and lasts for 30 seconds.
6. When 15 seconds remain in any bath step, the basket
dwells
for four seconds, then
rotates
clockwise for the remaining 11 seconds of the step. This ensures that the basket is rotating
clockwise when drain speed is commanded.
7. The drain
opens
15 seconds after drain speed is commanded.
8. The motor
runs
at drain speed for 30 seconds after the drain opens.
9. If the drain step is immediately followed by a bath step (without an intervening extract), the
basket
coasts
for 15 seconds before the next bath begins. The basket does not coast after a
drain step if the next step is an extract.
10. The basket coasts for 75 seconds after an extract step.
11. The
Door Unlock
button is enabled when the coast ends (75 seconds after the final extract
ends).
4.2.2.
Testing with the Display Kit
A kit consisting primarily of a vacuum fluorescent display and a wiring harness to connect
the display to the microprocessor controller is available from the Milnor
®
factory. Contact the
Milnor
®
parts department for details.
Seitenansicht 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare